ST2030 SIP fw upgrade via http
===============================

1. Web access: 

http://<ip>/admin.html 
usr: administrator
pwd: 784518

2. Application upgrade:
  
2.1. Go to Utility section, select Firmware upgrade (via http)
2.2. Browse to select the application file v2030SG.xxxxxx.x.xx.zz, then press Apply
2.3. When you are prompted to, click "Reboot and restart main application". Wait until you are back in the home page

3. Boot code upgrade (Optional, only if your phone does not show Boot Version 1.11 in homepage and you want to do MGCP-SIP swap)

3.1. If your homepage already shows Boot Version 1.11, go directly to step 4 below
3.2. Go to Utility section, select Firmware upgrade (via http)
3.3. Browse to select the boot code file "v2030_boot_v111.zz", then press Apply
3.4. When you are prompted to, click "Reboot and restart main application". Wait until you are back in the home page

4. DSP fw upgrade (Optional, if your dsp code is older than 3.20). 

4.1. If your home page already shows DSP version 3.20, go directly to step 5 below
4.2. Go to Utility section, select Firmware upgrade (via http)
4.3. Browse to select the dsp fw file "v2030_dsp_R11.1_SED_v320.zz", then press Apply
4.4. When you are prompted to, click "Reboot and restart main application". Wait until you are back in the home page.

5. Telephone configuration upgrade. This step is mandatory.

5.1. Go to Utility section, select Telephone Configure
5.2. Browse to select the configuration file Telconf2030SG_xxx.txt, then press Apply
5.3. When you are prompted to, click "Reboot and restart main application"

6. Check in Home page, that 
DSP version is 3.20
Boot Version is 1.11
Application version has changed according to your intended release package

7. Your phone should be ready to work in your environment since it will keep the previous configuration.


-EOF-